7. Refer to the Voice Terminal Configuration Form for this user to see what
restrictions you plan to assign to this voice terminal. Then touch
Call
Rstr
until the green light beside it shows the code for the call restric-
tions you want this voice terminal to have. Each successive touch gives
you one of the following codes:
Steady green on
= unrestricted (all calls allowed)
Flashing green = toll restricted (intercom and local calls only
plus allowed lists, if you assign any)
Green off
= outward restricted (intercom calls only plus
allowed lists, if you assign any)
(See page 44 for more information about allowed lists.)
8. Repeat steps 6 and 7 of this procedure until you have assigned call
restrictions to all your voice terminals.
If you want to give a voice terminal the same call restrictions as one that
has already been set up, use the shortcut below.
NOTE:
When you copy the call restrictions, you also copy allowed-list
permissions, Dial Access to Line Pools, and line and pool assignments
from the original voice terminal.
●
Dial the intercom number or touch the Auto Intercom button of the
new voice terminal.
● Touch Copy.
●
Dial the intercom number or touch the Auto Intercom button of the
voice terminal whose restrictions you want to copy.
9. Touch
Adm Tel.
The lights next to the administration mode buttons flash again.
10. Continue to administer your system or leave administration mode by
following the boxed instructions on page 25.
43
