PROGRAMMING SIMULTANEOUS VOICE AND DATA CALLS
When a voice terminal in your system is connected to
a General
Purpose Adapter
and a
modem, it
can link the
user’s
computer terminal to a local
or
remote host com-
puter. With the Simultaneous Voice and Data Call feature, the user can place or
receive calls on his or her voice terminal without interrupting the exchange of data
between the computer terminal and the host computer. Use Centralized Voice Ter-
minal Programming or follow the procedure below to program this feature.
1. Go to the voice terminal you want to program.
2. Slide the T/P switch on the left side of the voice terminal to P.
The voice terminal rings every 5 seconds to remind you it is in program
mode.
3. Touch
Message
until the green light next to it shows the appropriate
code. Each successive touch gives you one of these codes:
Steady green on =
simultaneous voice and data calls permitted
Green
off =
simultaneous voice and data calls not permitted
4.
If you have more features
to
program on this voice terminal, you can
do so. Otherwise, slide the T/P switch to the center position to return
to normal operation.
82
