A SERVICE OF

logo

Section 2: Basic Installation
34 AXIS 540/640 User’s Manual
Using DHCP
in Windows
Follow these step-by-step procedure below to use the DHCP method:
1. Edit or create a scope in the DHCP manager of the DHCP
daemon. The entries included into this scope should include the
following:
range of IP addresses
subnet mask
lease duration
default router IP address
2. Activate the scope
3. Enable the DHCP_ENB parameter in the Configuration file of
the AXIS 540/640 using AXIS NetPilot or any other preferred
method.
Note: DHCP is only available in “+” and Token Ring models.