A SERVICE OF

logo

30
Reference Manual
00809-0100-4052, Rev AA
Section 5: Redundancy
April 2015
Redundancy
To configure network connectivity check:
1. Navigate to System Settings>Gateway>Ethernet Communication.
2. Enter the host system IP address in the Check Network Connectivity IP Address field.
3. Select Submit.
Figure 5-4. Network Connectivity Check (System Settings>Gateway>Ethernet
Communication)
5.6 Gateway replacement
When replacing or reintroducing a Gateway in a redundant system, always connect both the
primary and secondary Ethernet connections before powering the standby Gateway. If the
Gateway is being reintroduced (i.e. it was a part of the original redundant system), it will
automatically rejoin the redundant system. If the Gateway is new or has been set to default
configuration, it will need to be paired to the current active Gateway. Navigate to System Set-
tings>Gateway>Redundancy and follow the recommended actions on that page or follow the
procedure above to pair Gateways and form a redundant system.