A SERVICE OF

logo

Programming
Guide
The CrossPoint and MAV Plus matrix switchers can be remotely controlled via:
The Matrix Switchers Control Program (see the Matrix Software, beginning on
page 110)
Built-in HMTL pages (see HTML Operation, beginning on page 131)
SIS commands (see below)
This section describes the operation of the CrossPoint and MAV Plus matrix switchers via
SIS commands, including:
Serial Ports
Ethernet (LAN) Port
Host-to-Switcher Instructions
Switcher-Initiated Messages
Switcher Error Responses
Using the Command and Response Tables
Command and Response Table for SIS Commands
SIS Command and Response Table for IP- and Remote Port-Specific
Commands
Special Characters
CrossPoint and MAV Series Matrix Switchers • Programming Guide 89