Neo Series Bass Combo Amplifi er
Lock N’ Roll Transport System:
Roll transport system is designed for quick and
easy rolling of the combo on fl at surfaces such
as carpet, fl ooring, pavement, etc. To engage
the lock and roll handle, slide the locking latch
(below the handle) to the right, and lift the handle
up until it stops. Let go of the locking latch and
the handle will lock into place. Tilt the combo
back and you’re ready to go. The 3” wheels on the
bottom of the cabinet will automatically engage
and allow for smooth rolling.
Note: Never lift the amplifi er by the Lock N’ Roll
handle. It is designed to be used with the wheels
Set the power switch to Off and con-
nect the supplied power cord to the amplifi er’s AC
receptacle and an AC power outlet of proper voltage
(see safety information on page 4 for details).
If using an external speaker
cabinet, connect it to the free speaker output. If you
are using two 8 ohm or one 4 ohm external cabinet
with a combo amplifi er, disconnect the internal speaker.
Be sure not to exceed the recommended speaker load
Maximum Recommended Speaker Loads:
Note: If you are using a GK Horn Bi-Amp compatible
speaker cabinet, set it to Bi-Amp using the switch on
the back of the cabinet. (See Page 8 for more details
on GK’s Horn Bi-Amp System)
Initial Front Panel Control Settings:
controls and the Boost control to 12 o’clock. The
Voicing Filters should be turned all the way down to
get a fl at response. Set the Input and Master Volumes
Using an instrument (shielded)
cable, connect your bass to the Input jack and press
Input and Master Volume Settings:
master to 12 o’clock then gradually increase the
preamp volume control to a comfortable listening
level. If the Clip LED by the input jack lights up while
playing, engage the -14dB Pad button.
Quick Start
