Neo Series Bass Combo Amplifi er
Rear Panel Features
Cuts frequencies above 5kHz
When used, the signal path is
in-series, meaning all of the signal goes through the
Returns the Effects Loop signal
to the signal path. May also be used as a secondary
input for another instrument or CD player. The preamp
signal is not interupted if the Send jack is not used.
Parallel output comes directly off
of the input stage. Unaffected by the Mute button or
any of the preamp functions.
5 seconds during power-up, then turns blue when the
amp is ready. Should a fault occur, the amp will mute
and the LED will turn red until the fault is corrected.
this does, you should probably not be operating
Standard IEC Receptacle. The
power cord plugs in here.
2) 700W or 480W Amp Only:
jacks. Impedances Lower than 4 Ohms should not be
used. Higher impedances such as 8 Ohms, 16 Ohms,
or No Load are acceptable. One 4 Ohm, one 8 Ohm,
or two 8 Ohm cabinets are okay. One 4 Ohm and one
8 Ohm together is not recommended. The internal
speakers equal an 8 Ohm load. No damage will
result from operating the amplifi er with the speakers
High current twist-lock Speakon
output connectors. Pins 1+ and 1- send a fullrange
signal from the Main (Woofer) amplifi er. Pins 2+ and
2- send a signal 5kHz and above from the Tweeter
amplifi er. Use a four-conductor Speakon cable when
connected to a GK Horn Bi-Amp compatible speaker
cabinet. Use a standard two-conductor Speakon cable
when connected to a non-GK cabinet or if you’re using
a Speakon to ¼” adapter. See Horn Bi-Amp System
on page 8 for more information.
Do not connect a Speakon cable labeled “Bridge
Mode” to the Speakon Outputs. This may
result in damage to the amplifi er.
