© GBC Pro - Tech August 1999Page 6 - 44
F - 160 Operation and Maintenance Manual
Applications
Materials needed
• Prints ( Decals )
• Substrates
• Utility knife
• Leader board ( substrate width x 6” )
Set up
a) Replace the front infeed table.
WARNING
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
b) Press GAP
tt
tt
t to the required gap setting for
the substrate being used. The GAP DISPLAY
should reflect your desired setting.
GAP
PRESSURE
1/4
CAUTION
Sharp edges on a substrate should be filed
smooth and GAP manually adjusted.
Sharp edges can CUT the rollers!
If the thickness of the substrate is not
known, follow the procedure to manually
set the nip in Section 5.5.1 Manually nip
adjustment.
INFORMATION
c) Position the leader board in the middle between
the upper and lower main rollers.
d) Press FWD
ss
ss
s.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
WARNING
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
You may be CRUSHED or BURNED!
