F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 6 - 87
Applications
Figure 6.9.2 Unwind shaft
Core chucks
Core support
Clevis pin
Brake adjust
knob
Roll of
laminate
Saddle
g) Once the roll of thermal laminate is on the upper
unwind shaft, swing the upper unwind shaft
back into the saddle.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
CAUTION
h) Push the clevis pin back down to secure the
unwind shaft in its saddle.
i) Lift the clevis pin located in the saddle of the
lower unwind shaft.
Clevis pin
Saddle
j) Swing the lower unwind shaft out enough to
slide the roll of thermal laminate over the core
chucks on the lower unwind shaft. Refer to
Figure 6.9.2
INFORMATION
Twisting the roll of thermal laminate
while sliding makes loading the film
onto the unwind shaft easier.
k) Once the roll of thermal laminate is on the
lower unwind shaft, swing the lower unwind
shaft back into the saddle.
l) Push the clevis pin back down to secure the
unwind shaft in its saddle.
