F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 6 - 67
Applications
h) Press FWD
ss
ss
s.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
INFORMATION
Steps "i" and "j" will be performed
simultaneously.
WARNING
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
You may be CRUSHED or BURNED!
i) Push the leader board into the main roller nip
while stepping on the variable speed footswitch.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
j) Apply the minimum amount of brake tension on
the roll of thermal laminate to prevent it from
free spinning.
Excessive tension will cause the
substrate to bow.
INFORMATION
k) Once tentioned, let off the variable speed
footswitch/
l) Position the board with the glued sheet of Hot
Tissue and image against the leader board.
WARNING
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
You may be CRUSHED or BURNED!
m) using a slow speed, press on the variable speed
footswitch while guiding the board into the main
roller nip.
