Part No. 82233 Genie GS-2668 RT & Genie GS-3268 RT 19
Operator's Manual
Second Edition ยท Third Printing
FUNCTION TESTS
27 Depress the thumb rocker switch in the direction
identified by the yellow triangle on control panel.
Result: The steer wheels should turn in the
direction that the yellow triangle points on the
control panel.
Test Drive and Braking
28 Press and hold the function enable switch.
29 Slowly move the control handle in the direction
indicated by the blue arrow on the control panel
until the machine begins to move, then return
the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
30 Press and hold the function enable switch.
31 Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop.
Note: The drive brakes must be able to hold the
machine on any slope it is able to climb.
Test Limited Drive Speed
32 Move and hold a function enable/speed select
switch. Raise the platform approximately
6 feet / 1.83 m from the ground.
33 Press and hold the function enable switch.
34 Slowly move the control handle to the full drive
position.
Result: The maximum achievable drive speed
with the platform raised should not exceed
0.73 feet / 0.22 meters per second.
If the drive speed with the platform raised exceeds
0.73 feet / 0.22 meters per second, immediately
tag and remove the machine from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
35 Fully lower the platform.
36 Drive both wheels on one side onto a 4 inch /
10 cm block or onto a curb.
37 Raise the platform at least 6 ft / 1.83 m.
Result: The platform should stop and the tilt
alarm will sound at 180 beeps per minute.
38 Move the drive control handle in the direction
indicated by the blue arrow, then move the drive
control handle in the direction indicated by the
yellow arrow.
Result: The drive function should not work in
either direction.
39 Lower the platform and drive the machine off the
block.
