A SERVICE OF

logo

Open as PDF
next previous
3-10 P/N 480-0005-00-15
Chapter 3: Installation
Connect to PC Console (with CPU)
You will need to connect the Tenor CMS chassis to your PC’s serial port via RS-232 connection. (This con-
nection will be used when you assign an IP address to the chassis. For the instructions below, it is assumed you
are connecting to a PC.)
NOTE: For illustration purposes, the CMS240 (2 slot) AC unit is shown.
Figure 3-7 Connect to PC Com
NOTE: You must use a DB-9 Serial RS-232 cable with a DB-9 male connector (see section Chapter 2:
Hardware Components for pinouts) to connect the chassis to a PC.
1. Insert the male end of the DB-9 cable (grey cable if provided by Quintum) into the CPU card’s rear port
labeled Console. (See Chapter 2: Hardware Components for serial RS-232 connector pinouts.)
2. Insert the female end of the DB-9 cable into your workstation’s serial port (see your PC documentation for
more information about this port).
Chassis Rear (AC view)
10/100
Ethernet
1
2
3
4
5
6
7
8
DS1
Link TX/RX
Link TX/RX
CPU
2
4
8
3
7
26
15
TX/RX
1
2
3
4
Link
Config
1
2
3
4
Off
On
Console
10/100
Ethernet
1
0
CPU
2
4
8
3
7
26
15
TX/RX
1
2
3
4
Link
Confi g
1
2
3
4
Off On
Consol e
10/10 0
Et h er net
DB-9