Hewlett-Packard 800 Manual

A SERVICE OF

next previous

Expanding the OmniBook

Replacing Internal Hardware

3-6

If your new hard drive has screws in different positions from the old one, you

will also need to adjust the insulator sheet. Compare the location of the screw-

holes in the new hard drive with those in the insulator sheet. If there is no screw

at position A, then unfold the flap at position A, and lay it flat before laying the

hard drive down on the insulator.

8. Holding the new hard drive by its edges, lay it in place. The right edge of the

hard drive should be flush with the edge of the compartment.