Expanding the OmniBook
Replacing Internal Hardware
3-7
9. Grasp the right flap of the insulator and pull to the left to engage the
connection between the hard drive and the computer. Do not push down on
the hard drive. If the hard drive's connectors do not engage the computer's
connectors, pull the hard drive back out and try again. Then fold the insulator
sheet back over the hard drive.
10. If the ribbon cables are no longer tucked into the frame, then push them back
into the recessed openings with a paper clip, as shown below. Re-insert the
keyboard by engaging the four front tabs on the keyboard into the four slots in
the computer frame, pressing down on the keyboard as you insert the tabs.
Make sure the ribbon cables slide into the recessed openings and do not extend
under the keyboard.
11. Close the OmniBook, turn it over, and re-insert the five screws removed in
step 3.
CAUTION: Be sure you are using the correct screw holes for the new drive,
as determined in step 7. The new hard drive might use different holes from
the old hard drive.
Do not over-tighten the screws—screw just until you feel resistance.
