Setting up the network printer
Paper handling
Maintenance
Troubleshooting
Administration
Index
24
Printing
www.lexmark.com
Lexmark E320/E322 Printer
7 Print a test page to verify printer installation.
a Click Start Settings Printers.
b Click File Properties.
c On the General tab, click Print Test Page.
When a test page prints successfully, printer installation is complete.
Troubleshooting
At the server, do these steps in the order shown before you call the Customer Support
Center.
1 Make sure you are using TCP/IP for communications between the Windows server
and the MarkNet print server. For Windows NT Server 4.x or Windows 2000, use
either TCP/IP or LexLink.
2 Press the operator panel button with a brief button press to print a network settings
page.
Look under the TCP/IP heading on the network setup page to see if the TCP/IP
protocol is turned on (activated) in the print server.
If TCP/IP is turned off, use the IPX protocol to activate it. Select the printer and then
select the TCP/IP task. Check the Enable box to activate TCP/IP.
