A SERVICE OF

logo

4-24 Service Manual
4085-001
RIP-EMC Shield Assembly/RIP Card Removal
1. Remove the rear cover. Refer to Rear Cover Removal on
page 4-3.
2. Remove the power supply. Refer to Power Supply Removal on
page 4-19.
3. Disconnect (J14) RIP cable from the engine board.
4. Remove the six screws {A} from the RIP card.
5. Remove the RIP card. Note routing of cable.
6. Remove the six screws {B} from the shield assembly.
7. Remove the shield assembly.
Note: Anytime the RIP card is replaced, a course alignment has to
be done. Refer to Coarse Alignment on page 3-5.