Other Information
Troubleshooting
Most prol_lems you encounter _.\ilh your TV you can correct by consulting tile Troubleshooting list that follows.
TV Problems
TV won't turn on
Press the' "J_+bttltt)zl
Make sure' the T\ is phigged in
Check the \_al! receptacle (or c,xfc'i_sion cord) t_ make sure it is "live" by plugging in something else,
Sonic?thing lllight be \t roi/g with your Fell]oft' con{rol. Press the POWER button on the from of the "IX/'. If tile TV turns on,
check the ic't/l()lc' c(inlrol st)hitiOllS on p. _zl
"lhe Ii_ml pane! btttlol/s ilia) bt, locked (disabled). [:se the renlote control to unlock the front panel controls by selecting the
bif_#l! I'aJ#_,//7l+,_k m the IJaJ%>#ll(ll(,I;IIDXJls nienu aild choosing Viem
Buttons don't work
If you'le rising the remote control, press the TV button first to make sure the remote is in TV mode.
_ll_e front panel buttons may be locked (disabled). Use the remote control to unlock the front panel controls by selecting the
Fro_tt Panel Block in tile Patv*_tal Co_ltrols menu and choosing View.
Unphig the TV for t_xo minutes and then phlg it back in. Turn the TV on and try again.
TV turns off while playing
Scheduled off fLmction may ha\e been activated. Go to p. 50 for instructions.
Electronic protection cncuit may have heen activated because of a power surge. Wait 30 seconds and then turn the TV on
again If this happens fl-equently, tile voltage in your house may be abnormally high or low.
"IV turns on unexpectedly
Scheduled On or Watch from the GUIDE Plus+ system may have been activated, Go to p, 50 for instructions.
Blank screen
Make sure th_ conlponent connected to the TV is turned on.
Try another channel.
Press RF,SET, in case the picture controls are set too low.
When I turn on the TV an icon is moving on the screen
Make sure you have temoved the Demo Pin from tbe G-LINKjack on tile back of your "IV,
No sound, picture okay
_yl)e St)'Lilld iN nltltt'd PTes$ _h fe volt.il"Fl_ _lp I__titton to restore sound.
Maybe speakers are lurncd off Check the Audio Output and Speakers control panel in the Audio menu. Go to p. 47 for
detailed instructions
If using S-V[DEt) cahles t<_ connect a component, remember to also connect the component's left and right Audio Output Jacks
to the "]_,"'s Iclt and right INPUT Jacks.
Can't select certain channel
Channd may bc hlocked or not approved in the PareHtgglConlrols nleiItl.
If using ;t \CR, m:lke sure the "l_.' VCR button on the VCR is in the correct mode (press the TV/VCR button on your VCR),
Noisy stereo reception
The statism might b_. \_eak, Press the SOUNI) button on your remote control to clmnge from stereo to morn)
52 Chapter 5
