33
EN
Editing Recorded MDs
6 Press DISPLAY/CHAR to select the character
type as follows:
To select Press DISPLAY/CHAR repeatedly
until
Uppercase letters “A” appears in the display
Lowercase letters “a” appears in the display
Numbers “0” appears in the display
7 Turn AMS to select the character.
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
! ” # $ % & ’ ( ) * + , – . / : ; < = > ? @ _ `
You can press DISPLAY/CHAR to change the
character type at any time during Step 7 (see
Step 6).
8 Press AMS to enter the selected character.
The cursor shifts rightward and waits for the input
of the next character.
9 Repeat Steps 6 to 8 until you have entered the
entire title.
If you entered the wrong character
Press 0 or ) until the character to be corrected
starts flashing, and repeat Steps 7 and 8 to enter
the correct character.
To erase a character
Press 0 or ) until the character to be erased
starts flashing, then press EDIT/NO.
To enter a space
Press ) while the cursor is flashing.
10 Press YES.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press p.
Note
You cannot label a track or an MD while you are recording
over an existing track.
