masterpage:Left
(3 column)
filename[F:\My Document\mds-
s50\4230403131\4230403131\423040313MDSS50U2\GB05OPE-U2.fm]
model name1[MDS-S50]]
[4-230-403-13(1)]
12
Recording tips (continued)
1 While the deck is stopped, press MENU/
NO twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./>
repeatedly) until “S.Space On” appears,
then press AMS or YES.
3 Turn AMS (or press ./>
repeatedly) to select the setting, then
press AMS or YES.
4 Press MENU/NO.
Notes
• Smart Space does not affect the order of the track
numbers being recorded, even if the blank space
occurs in the middle of a track.
• Auto Cut is automaticallyturned on oroffin tandem
with Smart Space.
• If the deck continues recording pause for about 10
minutes afterthe Auto Cutactivated, recording stops
automatically.
Adjusting the recording level
You can adjust the recording level for both
analog and digital recordings.
1 Dosteps1to6of“Recording to MDs”
on page 8.
2 Play the portion of the program source
with the strongest output.
3 Press LEVEL/DISPLAY/CHAR (or
DISPLAY) repeatedly until the level of
the input signal appears.
4 While monitoring the sound, turn AMS
(or press LEVEL +/– repeatedly) to raise
the recording level to its highest level
without turning on “OVER” on the peak
level meters.
Avoid turning on these indicators
5 Stop playing the program source.
6 To start recording, continue from step 8
of “RecordingtoMDs” on page 8.
Tips
• To adjust the recording level, press LEVEL +/– on
the remote repeatedly during recording or recording
pause.
• Peak hold function freezes the peak level meters at
the highest level reached by the input signal.
1 While the deck is stopped, press MENU/
NO twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly)
until “P. Ho l d O ff ” (factory setting) appears,
then press AMS or YES.
3 Turn AMS (or press ./> repeatedly)
to select “P. H ol d On ”,thenpressAMSor
YES.
4 Press MENU/NO.
To turn off the Peak Hold Function,select “P.Ho ld
Off” in step 3 above.
Note
The volumecan onlybe increased up to +12.0 dB (for
analog recording) or +18.0 dB (for digital recording).
Therefore, if the output level of the connected
component is low, it may not be possible to set the
recording level to maximum.
Checking the remaining
recordable time on the MD
Press DISPLAY on the remote repeatedly.
For the information in stop mode, see page 17.
For the information during recording, see
page 8.
To Select
Turn on Smart Space
andAutoCut
S.Space On (factory
setting)
Turn off SmartSpace
andAutoCut
S.Space Off
