BIOS Setup Utility SY-P4I875P DRAGON 2 V1.0
55
3-1.3 OnChip IDE Device
Caution: Change these settings only if you are already familiar
with the IDE settings.
The [OnChip IDE Device] option changes the settings of the 82801ER
(ICH5R) IDE controller. These settings do not influence the ALi M5281
controllers.
The following screen shows setup default settings.
Phoenix – Award BIOS CMOS Setup Utility
OnChip IDE Device
IDE 1,2 /SATA 1,2 IDE only
IDE HDD Block Mode Enabled
Item Help
IDE DMA transfer access Enabled
On-Chip Primary PCI IDE Enabled
IDE Primary Master PIO Auto
IDE Primary Slave PIO Auto
IDE Primary Master UDMA Auto
IDE Primary Slave UDMA Auto
On-Chip Secondary PCI IDE Enabled
IDE Secondary Master PIO Auto
IDE Secondary Slave PIO Auto
IDE Secondary Master UDMA Auto
IDE Secondary Slave UDMA Auto
*** On-Chip Serial ATA Setting ***
SATA Mode IDE
On-Chip Serial ATA Disabled
x Serial ATA Port0 Mode Primary Master
x Serial ATA Port1 Mode Primary Slave
Menu Level
[Disabled]: Disabled SATA
Controller.
[Auto]: Auto arrange by
BIOS.
[Combined Mode]: PATA
and SATA are combined.
Max. of 2 IDE drives in each
channel.
[Enhanced Mode]: Enable
both SATA and PATA. Max.
of 6 IDE drives are
supported.
[SATA Only]: SATA is
operating in legacy mode.
ÇÈÆ:Move
Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7: Optimized Defaults
After you have completed the changes, press [Esc] and follow the instructions
on your screen to save your settings or exit without saving.
