B060-032 Front View
1. Firmware Upgrade Recovery Switch
During normal operation and while performing a firmware upgrade, this switch should be in the
NORMAL position. If a firmware upgrade operation does not complete successfully, slide this switch to
the RECOVER position and do a warm reset (see p. 31), to return the switch to its prior firmware state.
After returning the switch to its prior firmware state, slide the switch back to the NORMAL position to
attempt the firmware upgrade again, or to use the switch with its prior firmware.
2. Port LEDs
The Port LEDs are multicolored (Red / Green / Amber), and provide status information about their
corresponding CPU Ports as follows:
Color Condition Indication
Amber Steady Port is selected and the connected server is on.
Flashing Port is selected; Port is connected to a powered ON KVM switch
Red Steady Port is selected but connected server is OFF
Green Steady Port is not selected, the connected server is ON
Flashing Port is not selected: Port is connected to a powered ON KVM switch
Off Port is not selected and the server is OFF
3. Reset Switch
Pressing this switch in performs a System Reset.
Note: This switch is semi-recessed and must be pushed with a thin object - such as the end of a paper
clip, or a ballpoint pen.
4. Power LED
Lights to indicate that the B060-032 is powered up and ready to go.
5. Station ID LED
The B060-032’s Station ID is displayed here. If this is a Single Station installation (see p. 8), or the First
Station on a Daisy Chained installation (see p. 10), the B060-032 has a Station ID of 01.
On a Daisy Chained installation, the B060-032 auto-senses its position and displays the Station ID that
corresponds to its place in the chain. (see Port ID Numbering, p. 17 for details).
