Filter
Top Products
6
TRSM Installation
4
Grasp the inject/eject handles of the module and push them outward as
shown in Figure 2.
Figure 2
Handles in Outward Position
5
Remove the module from the system.
6
Place the module in its antistatic bag.
Installing the TRSM
The installation procedure takes only a few minutes to complete. You need
a small, flat-blade screwdriver.
NOTE:
Only the LMM may be inserted in slot one of the LANplex system. The
system will not operate if any other module is inserted into slot one. Slot one
of the LANplex 6004 is the bottom slot, and slot one of the LANplex 6012 is
the first slot on the left.
To install the TRSM in an empty slot in the LANplex system, perform the
following steps:
1
Discharge yourself of static electricity by placing the ESD wrist strap on your
wrist and clipping the alligator clip to the mounting screw located next to
the black ground symbol on the system’s right mounting bracket. See
Figure 3. If your system does not have mounting brackets, touch the rear
panel.
Module faceplate
Module faceplate