Filter
Top Products
12
Installation and Setup (Continued)
MACHINE BED HEIGHT
The case sealer is equipped with four adjustable
legs that are located at the corners of the
machine frame. The legs can be adjusted to
obtain different machine bed heights. See the
"Specifications" section.
TAPE LEG LENGTH
Taping heads are preset to apply 70 mm
[2.75 inches] long tape legs. To change tape leg
length to 50 mm [2.0 inches], refer to Section II,
"Special Setup Procedure—Changing the Tape
Leg Length".
To adjust the machine bed height, do the
following:
Figure 2-10—Machine Bed Height Adjustment
1. Use appropriate material handling equipment
and blocking techniques to raise the machine
frame to allow adequate leg adjustment.
2. Using a 6 mm hex wrench, loosen the socket
head screws that hold the inner leg assembly
to the machine as shown in Figure 2-10.
3. Adjust the leg length for the desired machine
bed height. Adjust all four legs equally.
4. Retighten the screws.
Note: It is not necessary to fasten the
machine to the floor.
• To reduce the risk associated with muscle
strain:
− Use the appropriate rigging and material
handling equipment when lifting or
repositioning this equipment.
− Use proper body mechanics when removing
or installing taping heads that are moderately
heavy or may be considered awkward to lift.
WARNING