Filter
Top Products
18
7-INSTALLATION (continued)
2010 December
800ab-NA
7.5 Removal of Plastic Ties 7.6 Assembly Completion
Cut the plastic ties holding the lower taping head in
position
(Figure 7-4).
Figure 7-4
Install inclined rollers onto infeed end of each drive belt
assembly. Remove M6 lock nuts (4)and M6 plain wash-
ers (4) from each drive assembly, position inclined roller
on each drive assembly and fasten with M6 plain
washers and M6 locking nuts (See Figure 7-5)
Figure 7-5
• To reduce the risk associated with
sharp blade hazards:
− Keep hands and fi ngers away from
tape cutoff blades under orange blade
guards. The blades are extremely sharp.
WARNING
Inclined Roller
Assembly
M6 Lock Nut (4)
M6 Plain Washer (4)
Cable Tie
Buff ng
Roller