Filter
Top Products
12
3M™ Multi-Touch Display User Guide
3M Touch Systems, Inc. Proprietary Information –
TSD-44310 REV B
Connecting the Display
To setup this display, please refer to the following figures and procedures.
• Be sure all equipment is turned off.
• Connect the DC adapter to the power connector (DC IN) on the monitor and the other
end into an electrical outlet.
• Connect the D-SUB cable from the display’s VGA input connector to the D-SUB
connector of your host computer and tighten the screws.
• Connect the DVI cable from the display’s DVI input to the DVI connector of your
host computer and tighten the screws.
• Connect the USB cable from the USB port of your display to the USB port of your
computer.
• Configure the touch screen. Refer to the “Touch Screen Driver Installation” section.
• Once the touch screen is configured, the monitor is ready for use.
• Connect the remote control cable to RJ-type port (optional). Don't connect telephone
or internet cable to RJ-type port. Adapter rating is 12Vdc 3A minimum, marked with
LPS.
Note: To ensure the LCD display works well with your computer, please configure the
display mode of your graphics card to make it less than or equal to 1920 x 1020
resolution and make sure the timing of the display mode is compatible with the LCD
display.
WARNING
To avoid the risk of electric shock which could cause serious injury or death:
• Plug power cord into appropriate grounded power source.
• Do not use a power cord that is frayed or otherwise damaged.
• Do not use a damaged display or power supply.
• Do not use a substitute DC power adapter. Use only the DC adapter provided for
the display.
• Do not use non-conforming replacement parts..
Supported Video Display Modes and Refresh Rates
Your video card should support one of the display modes specified below. If you select
an unsupported video mode, the display may stop working or display unsatisfactory
picture quality.