Filter
Top Products
© 3M 2008. All Rights Reserved. 3
3M™ Digital Projector DX70i Usage Notice
Use under the following conditions:
- In extremely hot, cold or humid environments.
- In areas susceptible to excessive dust and dirt.
1HDUDQ\DSSOLDQFHWKDWJHQHUDWHVDVWURQJPDJQHWLF¿HOG
- In direct sunlight.
Important Note
1. This product will detect the life of the lamp itself. Please be
sure to change the lamp when it shows warning messages.
2. Reset the “Lamp Reset” function from the On Screen Display
“Lamp Setting” menu after replacing the lamp module (refer
to page 36).
3. When switching the projector off, please ensure the projector
completes its cooling cycle before disconnecting power.
7XUQRQWKHSURMHFWRU¿UVWDQGWKHQWKHVLJQDOVRXUFHV
5. Do not use lens cap when projector is in operation.
6. When the lamp reaches the end of its life, it will burn out
and may make a loud popping sound. If this happens, the
projector will not turn back on until the lamp module has
been replaced. To replace the lamp, follow the procedures
listed under “Replacing the Lamp”. (see page 41)