Filter
Top Products
3M™ Multi-touch Display M2256PW User Guide 23
3M Touch Systems, Inc. Proprietary Information – 37531 Rev D
Table 2. Calibration Setup Stage
Offset Field Size Value Description
0 bmRequestType 1 0x21 Class,H2D,Interface
1 bRequest 1 0x09 Set Report
2 wValue 2 0x0303 Msb 03 = Feature
Lsb 03 = Feature Report ID
4 wIndex 2 0 Always 0
6 wLength 2 8 Always 8
Table 3. Data Stage
Offset Field Size Value Description
0 Report ID 1 0x03 Feature report ID
1 Report Subtype 1 0x04 Indicates a calibration request
2 bCalType 1 0x01 0x01 = Extended cal (CX)
3--7 Not used 5 0 Not used
The device stalls endpoint 0 if the command cannot be processed successfully. The
request cannot be processed if an invalid calibration type is given in the wValue field.
The request will also fail if the 2 calibration points do not fall within certain bounds
established by the firmware. These bounds require that the 2 calibration points be in
opposite quadrants of the sensor.
The host should issue a GetStatus request to determine the status of this request. The
status report includes a command status byte which will be set as shown below.
Table 4. Calibration Response
Command Status Byte Description
0 Calibration Failed
1 Controller is waiting for a touch in the lower left corner.
Calibration software paints a target in the lower left corner.
2 Controller is waiting for a touch in the upper right corner.
Calibration software paints a target in the upper right corner.
3 Calibration completed successfully.
The controller does not timeout waiting for touch. Use the soft reset command to abort
the calibration.
Determining Target Areas
The default calibration targets (points) are located 12.5% (1/8) inward from the corners
of the video image. For example, suppose the resolution of your Windows-based display
is 1680 x 1050. The Calibrate Extended command calculates the amount to move inward
as follows:
•
Amount to move inward in the X direction: 1680 x 1/8 = 210
•
Amount to move inward in the Y direction: 1050 x 1/8 = 131