3M MP300 Projector User Manual


 
3M™ Mobile Projector MP300
© 2012 3M. All Rights Reserved. 35
Reset Button
The reset button restarts the projector in the event the projector stops responding.
Reset the projector by disconnecting the video input and power, and then press the
reset button using an uncoiled paper clip. This will turn off the projector and allow you
to turn the projector on again.
Cleaning the Projector
1 Turn off the projector and disconnect power and other cables.
2 Use a soft cloth, such as the 3M™ High Performance Cleaning Cloth, to wipe off
dust. If the dust is difficult to remove, dampen the cloth with clean water and then wipe
the projector clean. Then use a clean cloth to dry the projector.
Important Note: Do not use cleaning chemicals or solvents to clean the projector.
Cleaning chemicals and solvents may cause the plastic parts to discolor.