Filter
Top Products
CHAPTER 2: NETWORK SETUP SET UP THE NETWORK FOR AUTHENTICATION
8E6 TECHNOLOGIES, R3000 ENTERPRISE FILTER AUTHENTICATION USER GUIDE 61
The entries made in this window will vary depending on
whether you will be using the invisible mode, or the router or
firewall mode.
1. In the Mode frame, select the mode to be used: “Invis-
ible”, “Router”, or “Firewall”.
2. In the Listening Device frame, set the Device to “eth0”.
3. In the Block Page Device frame:
• If using the invisible mode, select “eth1”.
• If using the router or firewall mode, select “eth0”.
If using the invisible mode, the Block Page Delivery
Method frame displays. Choose from either of the two
Protocol Methods:
• “Send Block Page via ARP Table” - this option uses the
Address Resolution Protocol method to find the best
possible destination MAC address of a specified host,
usually the R3000 gateway.
• “Send Block to Specified Host MAC Address” - using
this preferred method, the block page will always be
sent to the MAC address of a specified host, usually
the R3000 gateway.
Choose from either of the two Block Page Route To
selections:
• “Default Gateway” - this option indicates that the
default gateway on your network will be used for
sending block pages.
• “Alternate IP Address” - this option should be used
if block pages are not being served.
Enter the IP address of the router or device that will
serve block pages.
4. Click Apply.