Filter
Top Products
CHAPTER 2: NETWORK SETUP SET UP THE NETWORK FOR AUTHENTICATION
8E6 TECHNOLOGIES, R3000 ENTERPRISE FILTER AUTHENTICATION USER GUIDE 71
3. In the Virtual IP Address to Use for Authentication
field,1.2.3.5 displays by default. If using Tier 1 or Tier 3,
enter the IP address that from now on will be used for
communicating authentication information between the
R3000 and the PDC. This must be an IP address that is
not being used, on the same segment of the network as
the R3000.
WARNING: If the IP address entered here is not in the same
subnet as this R3000, the net use connection will fail.
4. In the NIC Device to Use for Authentication field:
• if using the invisible mode, enter eth1 (Ethernet 1) for
sending traffic on the network—in particular, for trans-
ferring authentication data.
• if using the router or firewall mode, enter eth0
(Ethernet 0).
5. Click Apply to apply your settings.
NOTE: If using the NT authentication method, you will later return
to this window to join the domain. See the section on Join the NT
domain in Chapter 3: NT Authentication Setup for information
about these procedures.