ABL electronic PIC12 Personal Computer User Manual


 
MikroElektronika:
Development
tools
-
Books
-
Compilers
17 5
page
mikroC
- C Compiler for Microchip PIC microcontrollers
mikroC
making it simple...
Prototype
void Eth_Init(char *addrP, char *dataP, char *ctrlP,
char pinReset, char pinIOW, char pinIOR);
Description Performs initialization of Ethernet card and library. This includes:
- Setting of control and data ports;
- Initialization of the Ethernet card (also called the Network Interface Card, or NIC);
- Retrieval and local storage of the NIC’s hardware (MAC) address;
- Putting the NIC into the LISTEN mode.
Parameter
addrP is a pointer to address port, which handles the addressing lines.
Parameter dataP is pointer to data port. Parameter ctrlP is the control port. Parameter
pinReset is the reset/enable pin for the ethernet card chip (on control port). Parameter
pinIOW is the I/O Write request control pin. Parameter pinIOR is the I/O read request
control pin.
Requires As specified for the entire library (please see top of this page).
Example
Eth_Init(&PORTB, &PORTD, &PORTE, 2, 1, 0);
Eth_Init
Prototype
void Eth_Set_Ip_Address(char ip1, char ip2, char ip3, char ip4);
Description Sets the IP address of the connected and initialized Ethernet network card. The
arguments are the IP address numbers, in IPv4 format (e.g. 127.0.0.1).
Requires This function should be called immediately after the NIC initialization (see Eth_Init).
You can change your IP address at any time, anywhere in the code.
Example
// Set IP address 192.168.20.25
Eth_Set_Ip_Address(192u, 168u, 20u, 25u);
Eth_Set_Ip_Address