Filter
Top Products
4 DAC960PG DAC960PJ Quick Installation Guide
5. Set the SCSI ID for each external disk drive to a unique address
between 0 and 15, but do not use address 7 (reserved for the controller).
Do not duplicate SCSI IDs used by internal drives designated for the
same channel. For information on how to set SCSI IDs, refer to the disk
drive documentation.
If you are using an external SCSI cabinet, please see the Caution note
above.
6. Connect a wide, high-density, 68-pin SCSI ribbon cable to the internal
SCSI connectors on the DAC960PG or DAC960PJ controller, and
connect the other cable connectors to any internal SCSI drives as
required (see Figure 3).
7. Connect an active terminator to the end of the SCSI ribbon cable at the
end farthest from the controller (see Figure 3).
Figure 3. Connecting Internal and External Drives
8. Connect a wide, round, 68-pin Very High Density Connector Interface
(VHDCI) cable to the external SCSI connector on the DAC960PG or
DAC960PJ controller, and connect the other end of the cable to an
external drive cabinet as required (see Figure 3). External drive
cabinets usually have termination built into the end of the SCSI bus.
Check the documentation that comes with your drive cabinet to be sure
this is the case. If not, use an active terminator at the end of the bus.
T
T
DAC960PG/PJ Controller