Filter
Top Products
Contents
Manual No. 775034 3
Installing the DAC960PG or DAC960PJ into the
System
1. With the power off, plug the DAC960PG or DAC960PJ controller into
an available PCI slot (see Figure 2).
Figure 2. Plugging the DAC960PG or DAC960PJ into a PCI Slot
2. Set the SCSI ID on each internal drive to a unique address between
0 and 15, but do not use address 7, as it is reserved for the controller.
See the documentation that comes with your drives for instructions on
how to do this.
ƽ Caution
If internal and external drives are used, be sure that no
drive addresses are duplicated. External SCSI
cabinets usually automatically assign drive addresses
according to where in the cabinet the drives are
located.
3. Disable termination on all drives connected to the controller. See the
documentation that comes with your drives for instructions on how to
do this.
4. Enable termination power on all drives connected to the controller. See
the documentation that comes with your drives for instructions on how
to do this.
Plug Controller into
any Available PCI
Slot
System Board