Filter
Top Products
9
&T8 Perform Local Analog Loopback Test and
Self-Test
&U_ &U0 Enable Trellis Coding @ V.32
&U1 Disable Trellis Coding @ V.32
&V_ &V0 Displays Active and Stored Profile 0
&V1 Displays Active and Stored Profile 1
&W_ &W0 Stores the active profile as Configuration
Profile 0
&W1 Stores the active profile as Configuration
Profile 1
&Y_ &Y0 Configuration Profile 0 active upon Power
on or reset
&Y1 Configuration Profile 1 active upon Power on
or reset
&Zn=x n=0-3 Store telephone number x into non-volatile
RAM
%E_ %E0 V.22bis auto-retrain disabled
%E1 V.22bis auto-retrain enabled
3.5 MNP/V.42/V.42bis Commands
%An n=0- Set auto-reliable fallback character to n (where
127 n = 0 to 127,ASCII). Requires the \C2 setting
%C_ %C0 Disable MNP Class 5 data compression
%C1 Enable MNP Class 5 data compression
%D_ %D0 512 byte dictionary for V.42bis
%D1 1Kbyte dictionary
%D2 2 Kbyte dictionary
\C_ \C0 Do not buffer data during LAPM/MNP
handshaking
\C1 Buffer all data for 4 seconds, until receiving
200 characters or until a packet is detected
\C2 Do not buffer data; switch to normal mode
when fallback character is detected
\G_ \G0 Disable DCE flow control
\G1 Enable DCE flow control
\N_ \N0 Normal data-link only
\N1 Direct data-link only
\N2 MNP data link only
\N3 MNP/Normal data link
\N4 V.42 data link only
\N5 V.42/Normal data link