Filter
Top Products
11
+FLID=n Local ID string (TSI/CSI)
+FMDL? Request DCE Model
+FMFR? Request DCE Manufacturer
+FPPR: Partial Page Report Response
+FPTS: Receive Page Transfer Status Response
+FPTS: Transmit Page Transfer Status Response
+FPTS=n Page Transfer Status Parameter
+FREV? Request DCE Revision
3.7 Voice Mode Commands
#VA=m Enable/disable AGC
#VAA=n Select auto-answer mode
#VB=f1,t Generate beep tone(f1=frequency,t=duration)
#VBL=n Sets voice buffer length control
#VBO=n Set binary offset mode
#VBS=n Specify data transfer via DMA
#VC Disable, Enable <DLE><CAN> and DTMF
abort
#VCH=n Set DMA channel
#VDR=e,r Enable distinctive ring detection
#VD0 Transmit voice data
#VD1 Receive Voice Data
#VF=n Set FIFO size
#VG=n Gain setting in voice record mode
#VH=n Energize relay
#VL Set run-length encoding
#VM=n Microphone command
#VNH=n Set hook behavior for fax and data calls within
voice calls
#VRA=n Ringback goes away timer
#VRN=n Ringback never came timer
#VSC=n Set compression mode to n
#VSD=0,1,2 Silence deletion control (disable, 1 sec, .5 sec.)
#VSI=n Set silence end of message timer
#VSM=n Set CODEC mode to n
#VSn Activate voice mode (DTE rate n)
#VSP=n Set monitor mode
#VSR=n Enable actions and/or speakerphone response
codes
#VSS=n Set sample rate to n
#VST Set silence threshold -43dBm/-47dBm
#VSV Transmit voice data, listen for DTMF and
CNG
#VTI=n Supervision point qualifier
#VTn Controls command mode DTMF and CNG
detection