Filter
Top Products
11
Using the Adaptec SCSI Card 39160 and SCSI Devices
Using the Adaptec SCSI
Card 39160 and SCSI
Devices
This section provides useful information on using the Adaptec SCSI
Card 39160 and your SCSI devices. For more information about a
specific SCSI device, refer to the documentation for that device.
Using SCSI Devices
Caution:
Do not
connect SCSI devices to more than two of
the three SCSI Channel A connectors at the same time.
Using SCSI Hard Disk Drives
■
If you connect a SCSI hard disk drive to the Adaptec SCSI Card
39160 that was previously connected to a different SCSI card,
you must low-level format the drive before you can use it. Back
up the data on the drive before you move it! (See
Using SCSI
Disk Utilities
on page 24 for information on using the SCSI
Select
format utility.)
Caution:
A low-level format destroys all data on the
drive. Be sure to back up the data before performing a
low-level format.
■
Every SCSI hard disk drive must be physically low-level for-
matted, partitioned, and logically formatted before it can be
used to store data. Most SCSI drives are pre-formatted at the
factory. If your SCSI hard disk drive has
not
been pre-format-
ted at the factory, and if your computer is running under DOS,
Windows
®
3.x, or Windows 95/98, you can format the disk
with the DOS
Fdisk
and
Format
commands. (See the DOS and
Windows documentation for more information.) To format