Filter
Top Products
Configuring the Terminal
10 Megabit Modem 310F and 320F User Manual
CONFIGURING THE TERMINAL
Whether you are using an ASCII terminal or PC running a terminal emulation program, such as
Hyperterminal, you must configure the communication settings as indicated in this section,
including designating the connection type and communications port. See your terminal
emulation program or operating system documentation for instructions.
1 Configure these communication settings:
• 9600 to 19,200 baud
• no parity
• 8 data bits
• 1 stop bit
• no flow control
2 Set the terminal emulation mode to ANSI.
LOGGING ON AND NAVIGATING THE INTERFACE
Using the management interface, you can manage both the Megabit Modem 310F and 320F.
The header on each screen identifies the modem you are currently managing:
• ATU-C is the Megabit Modem 310F.
• ATU-R is the Megabit Modem 320F.
Logging On to the Local Modem
1 Press the several times to activate the autobaud feature and to display the
Logon Password screen.
Through the Megabit Modem 310F (ATU-C) System Configuration menu,
you can disable the console port on the Megabit Modem 320F (ATU-R).
Use an ASCII terminal or PC running a terminal emulation program to access
the management interface.
SPACEBAR