Filter
Top Products
SmartView Installation and Use Page 17
3.4 Keyboard hotkey control
SmartView can be conveniently controlled by selecting channel, autoscan mode or
security locking from the keyboard. All of the hotkey control commands are invoked
by holding down the two hotkeys and then pressing a command key. By default, the
two hotkeys are ‘CTRL’ and ‘ALT’, although other combinations can be selected by
reconfiguring the hotkeys (see section 4.5). Once the hotkey command has been
activated you will need to release the hotkeys and the command key before a new
hotkey command is accepted by the SmartView. HOTKEYs + TAB is an exception
and this allows you to 'tab through' the ports by holding down the hotkeys and
repeatedly pressing TAB. If the SmartView has been set to cycle between active