Filter
Top Products
SmartView Installation and Use Page 2
Radio Frequency Energy
Shielded cables must be used with this equipment to maintain compliance with radio
frequency energy emission regulations and ensure a suitably high level of immunity
to electromagnetic disturbances.
European EMC directive 89/336/EEC
This equipment has been tested and found to comply with the limits for
a class B computing device in accordance with the specifications in
the European standard EN55022. These limits are designed to
provide reasonable protection against harmful interference. This
equipment generates uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions may
cause harmful interference to radio or television reception. However,
there is no guarantee that harmful interference will not occur in a
particular installation. If this equipment does cause interference to
radio or television reception, which can be determined by turning the
equipment on and off, the user is encouraged to correct the
interference with one or more of the following measures: (a) Reorient
or relocate the receiving antenna. (b) Increase the separation between
the equipment and the receiver. (c) Connect the equipment to an
outlet on a circuit different from that to which the receiver is
connected. (d) Consult the supplier or an experienced radio / TV
technician for help.
FCC Compliance Statement (United States)
This equipment generates, uses, and can radiate radio frequency
energy and if not installed and used properly, that is, in strict
accordance with the manufacturer’s instructions, may cause
interference to radio communication. It has been tested and found to
comply with the limits for a class A computing device in accordance
with the specifications in Subpart J of part 15 of FCC rules, which are
designed to provide reasonable protection against such interference
when the equipment is operated in a commercial environment.
Operation of this equipment in a residential area may cause
interference, in which case the user at his own expense will be
required to take whatever measures may be necessary to correct the
interference. Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.
Canadian Department of Communications RFI statement
This equipment does not exceed the class A limits for radio noise
emissions from digital apparatus set out in the radio interference
regulations of the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de la
classe A prescrites dans le règlement sur le brouillage
radioélectriques publié par le ministère des Communications du
Canada.