Filter
Top Products
10
Global user (IP network port)
The AdderView CATxIP 1000 models provide
an autosensing Ethernet IP port that can
operate at 10 or 100Mbps, according to the
network speed. The AdderView CATxIP 1000
models are designed to reside quite easily at
any part of your network:
• They can be placed within the local
network, behind any firewall/router
connections to the Internet, or
• They can be placed externally to the local
network, on a separate sub-network or with an open Internet connection.
Wherever in the network an AdderView CATxIP 1000 is situated, you will need
to determine certain configuration issues such as address allocation and/or
firewall adjustment to allow correct operation. Please refer to Networking
issues within the Configuration chapter for more details.
IMPORTANT: When an AdderView CATxIP 1000 is accessible from the public
Internet or dial up connection, you must ensure that sufficient security measures
are employed.
To connect the Global user (IP network) port
1 Depending upon where in the network the AdderView CATxIP 1000 is being
connected, run a category 5, 5e or 6 link cable from the appropriate hub or
router to the AdderView CATxIP 1000 unit.
2 Connect the plug of the link cable into the IP port on the front panel of the
AdderView CATxIP 1000 unit.
3 Configure the network settings as appropriate to the position of the
AdderView CATxIP 1000 within the network - see Networking issues for
details.
GLOBAL
USER
IP
LOCAL
USER
POWER
IN
POWER
SWITCH
COMPUTER
SYSTEM
CAM
Category 5, 5e or 6 cable
from Adder X100/X200
module
AdderView CATxIP
1000 front panel