Filter
Top Products
AdderView GEM Installation and Use Page 31
F1 - Display firmware first digit (Note: F1 is FF followed by 11 NOT ll)
F2 - Display firmware second digit
F3 - Display firmware third digit
F5 - Restore PS/2 mouse function to the currently selected CPU’s mouse port
F6 - Restore IntelliMouse function to the currently selected CPU’s mouse port
F8 - Reset all configurations to factory default settings. An ‘r’ will show briefly on the
display to confirm that the reset has been completed.
4.7 Setting a security password
There are many situations where unrestricted access to corporate file servers or
sensitive information needs to be controlled. In such circumstances, the AdderView
GEM can be locked away in a room or secure cabinet and controlled remotely. In
this mode typing the keyboard hotkeys together with 'L' will blank the screen,
disconnect the keyboard and mouse from all of the computers and display ‘P’ on the
AdderView GEM display. Control can only be regained by typing the correct
password on the keyboard.
To set the password in configure mode, first type ‘P’ then (return). The display on
AdderView GEM will change to show ‘=' and you can then type your password. The
password is not case sensitive and can be any combination of key strokes, including
the function keys, but excluding the (ctrl), (alt), (shift) and (return) keys. When you
have typed in your password type (return) to register it in the stored memory. Do not
worry if you type the password incorrectly, you can always re-enter configure mode
and set the password again. If you have lost the password and the AdderView GEM
is locked, the unit may be unlocked by powering down the AdderView GEM, entering
configure mode at power on (see section 2.6), and performing a complete reset
using the F8 function.
NOTE - The password consists of a combination of key strokes rather like the code
to a safe. The key strokes are not case sensitive and can include all the keys on the
keyboard (except ctrl, alt, shift and enter). Consequently the following 'password'
would be valid:
oFREDoFRED
gg