Filter
Top Products
SmartView Installation and Use Page 20
The SELECT key can also be used to access the SmartView’s configuration mode
(see section 2.5). To do this press the key and hold it down for 5 seconds until ‘C’
appears on the SmartView’s front panel display.
An optional remote controller is also available for the SV4PRO and SV8PRO models
which replicates the SELECT key and display, but can be located remotely from the
SmartView. This is particularly useful in applications where the SmartView is located
away from the desktop. The remote controller can be conveniently attached to your
keyboard with a couple of Velcro strips to give instant channel information and key
control.
AUTO key
The AUTO key puts the SmartView into auto-scan mode. The ports scanned and the
scan time can be selected by options L and T in configure mode (see section 4.2).
AUTO and SELECT keys pressed together
(Lock function)
Pressing the AUTO and SELECT keys together will cause the SmartView to select
channel 0 and disable all video output. If a security password has been set then the
SmartView will lock, display P and wait for the password to be entered before
unlocking the SmartView.
AUTO and SELECT keys pressed together for 5 seconds
(keyboard and mouse reset function)
After 5 seconds the SmartView’s display will blank and power to the shared
keyboards and mice will be switched off causing a complete reset of these devices.
After several further seconds the power will be re-applied and normal operation is
resumed. This reset function does not reset the computer connections to the
SmartView.