Filter
Top Products
SmartView Installation and Use Page 21
4. SmartView configuration options
All the options described in this section are entered in SmartView configure mode -
see section 2.5 for instructions on entering configure mode.
4.1 Screen saver time delay
SmartView contains a programmable screen saver which will blank the display after
the set time delay with no keyboard or mouse activity. Simply typing at the keyboard
or moving the mouse will re-enable the display. The display will flash whilst the
SmartView is in screen save mode.
B1 - screen saver disabled (default)
B2 - Blank screen after 1 minute of inactivity
B3 - Blank screen after 2 minutes of inactivity
B4 - Blank screen after 4 minutes of inactivity
B5 - Blank screen after 8 minutes of inactivity
B6 - Blank screen after 12 minutes of inactivity
B7 - Blank screen after 16 minutes of inactivity
B8 - Blank screen after 20 minutes of inactivity
4.2 Display options
The SmartView display has a flashing dot which will activate whenever the keyboard
or mouse are used. Certain users may prefer to disable this flashing dot by setting
the D2, D4 or D6 options. The remote control pad / display is designed to fit on the
left or right hand side of the keyboard or monitor. Select the mode required so that
the port number appears in the correct orientation. Modes D5 and D6 are special
modes that support a monitor light module for use in banking and dealing room
applications where the keyboard and mouse only are being switched. The monitor
lights show which monitor is currently being controlled by the shared keyboard and
mouse.