Filter
Top Products
_____________________________________________________________________________
IP POWER PAGE 7 OF 24
Rear interface port description (from left to right):
90-240VAC power input port
Power switch: The ON/OFF power switch for the IP Power 9258 itself.
OUT1 - OUT4: 4 individually switched AC outlets
3. Hardware and Software Installation
Before you start to use the IP Power 9258, please follow the steps below:
1) Check the package to make sure the contents are complete
2) Prepare an Ethernet hub or router for accessing the IP Power 9258
3) Check the voltage of the power supply to make sure it is AC 110-240 volt
4) Confirm the specifications of your power cable. (For IP Power 9258S: for 220-250V, use the
10A power cable. For IP Power 9258T: for 100-120V, use the 15A power cable.)
Hardware installation
1. Connect the IP Power to the hub using a Cat5 network cable (for remote control, you
may then connect the hub or router to the Internet)
2. Connect the AC IN power adapter to the IP Power
3. Connect the power adapters of equipment to be controlled to corresponding OUT port
of the IP Power
4. For 220-250V, please use power wire, which can support 10A current. Maximum
output current: (total) 10A, (individual) 6A.
For 100-120V, please use power wire which can support 15A current. Maximum output
current: (total) 15A , (individual) 6A.
5. Power on your PC and the power adapter of IP Power
_____________________________________________________________________________
IP POWER PAGE 8 OF 24
Software installation
Once you’ve connected the power supply and network cable to the IP Power’s RJ45 network port,
install the software by following the steps below:
1. Start your computer, insert the IP Power CD, and locate the file named ipEdit.exe..
2. Copy the file to your desktop (or another directory if you prefer).
4. Initial Settings
1. Ensure you have installed the ipEdit.exe program as described in
the previous section, Software Installation.
2. Ensure that your PC is connected to the same network as the IP
Power, and that the IP Power is powered on.
3. Run ipEdit.exe by double clicking the ipEdit icon. The default Ethernet address of the
IP Power will be found and displayed. The default name of the IP Power is: IP 9258
4. Click IP 9258 in the left of the window and the IP Power’s name and IP address will
display in the right hand fields. You can rename the IP Power or change its IP address
or default gateway address. Click Update to apply the new settings. The new settings
will be working in 20 seconds.