Filter
Top Products
_____________________________________________________________________________
IP POWER PAGE 9 OF 24
5. Double click the name of the IP Power, and your browser window will open and
connect to the unit automatically. Alternately, manually type the IP address of the IP
Power into your browser.
NOTE
The IP Power 9258’s default IP address is 192.168.0.50 and its subnet mask is
255.255.255.0. The IP address of your computer should be in the same subnet with
that of IP Power’s (by default this subnet is 192.168.0.xxx), so that you can access
the IP Power control web pages.
Typically, you will want to find out the IP address of your PC and set the IP Power to
reside on the same subnet. To find out the IP address of your PC:
Select Start
Run
then type in cmd
in the MS-DOS window, type in ipconfig
The IP address of the PC is 192.168.100.31, so the IP Power has been set to
192.168.100.168. Both of these address are on the 192.168.100.xxx subnet.
You may also change the PC’s IP address to be on the same subnet as the IP
Power (by default 192.168.100.xxx), in Control Panel
Network Connections
Local Area Connection
Properties
Internet Protocol (TCP/IP) Properties.
The default username and password of IP Power 9258 are:
Username: admin
Password: 12345678
PC or server software shutdown
The IP Power 9258 can also safety shutdown a PC or server through the network before being
powered off. This allows you to remotely shut down a PC/server attached to IP Power 9258 using
the usual Windows safe shutdown procedure. Before using the software shutdown function,
please note:
You will need to install the IP9258service.exe program from the IP Power CD as
detailed below
_____________________________________________________________________________
IP POWER PAGE 10 OF 24
If you are running programs such as Microsoft Office the safe shut down may not
automatically save open documents or files which may result in lost data.
To allow enough time for the PC/server to safely shut down before being powered
off, please set the delay time at 30 or 60 second on the IP Power control web pages
Setup
Delay Switch.
The PC/server to shut down must be on the same Ethernet network and on the
same subnet as the IP Power.
Installing IP9258service.exe
1. Insert the IP Power CD in the PC/server which is to be enabled for software shutdown
2. Install the IP9258config.exe , by selecting the SDK button on the LHS then selecting
9258 SDK in the menu. Then double click Shutdown Program and run
IP9258config.exe. On the install menu select the LHS bottom button to place the
IP9258Service icon on your desktop. Click this icon then select the IP9258config.exe
program
3. Fill in the fields as follows:
IP9258 Address: The IP Power’s IP address
HTTP Port: The port of the IP Power control web pages – this will be 80 unless
you have changed it
Username: admin
Password: The IP Power admin password (default 12345678)
Power Number: The OUT power outlet the PC/server is connected through – if
many PC/servers are connected through the one power outlet and are
registered with the same IP Power unit, they will all be shutdown at the same
time
Click Save Change, Install Service then Start Service. Restart the PC/server, then it
will be enabled for software shutdown.