Filter
Top Products
_____________________________________________________________________________
IP POWER PAGE 11 OF 24
5. Control Using a Browser
Type the IP address of the IP Power into your web browser’s address field to access the IP Power
control web pages. The username is admin and the default password is 12345678. Enter these
credentials, or the password you have set. Click OK to enter the IP Power control web pages.
Control the power supply of the outlets
Select the Set Power from the left hand menu.
IP Power 9258 can control 4 outputs individually or at the same time. You can choose to power
off and power on an outlet. You may also set the time to delay before performing the chosen
action under Timer, by entering the time to delay in seconds and selecting On.
Querying the power state of the outlets
_____________________________________________________________________________
IP POWER PAGE 12 OF 24
Click Set Power again to refresh the status. The state of each power outlet is displayed under the
Control column.
System settings with browser
You may set the password, IP address, e-mail address, timer setting, perform an online firmware
update, and set the time of the IP Power through the IP Power control web pages.
Setting the password for IP Power
Select Change password from the left hand menu. The default password 12345678. You may
can change it to a password of your choosing (no longer than 8 characters). Click Apply to save
the change.
NOTE
If you lose or forget the admin password, enter the username super user at the log in webpage
and then click OK. Then turn the power off for a few seconds before turning the power back on.
The IP Power will to be reset to using the default password of 12345678. Note: There is space
between super and user.
Setting the IP Power’s IP address
Select Setup from the left hand menu. Fill in the new IP Address, Subnet Mask, Default Gateway,
and DNS server address. If your network has a DHCP server automatically allocating network
settings, you may choose to enable the IP Power’s DHP Client. The Beeper sound may also be
enabled or disabled on this page.
If the IP Power is connected to your Local Area Network (LAN):
You may set a fixed IP address or have it automatically assigned by a DHCP server. It is
suggested that you use a fixed IP address so that it is always known.