Filter
Top Products
Chapter 3. Configuration
61200659L1-1 MX2800 STS-1 User Manual 3-27
UEQ-P (Path Unequipped)
The controller card detects that the path is
unequipped. The path is unequipped if it is not
provisioned. Byte C2 of the STS path overhead
is set to zero.
SLM-P (Path Signal Label Mismatch)
The controller card is detecting a signal label
mismatch. A received signal label is
mismatched if it does not equal the locally
provisioned value or the value "equipped non-
specific".
TX LOS (Transmit Loss of Signal)
The controller card's transmitter has failed.
XCV (Excessive Code Violations)
The controller is receiving excessive code
violations exceeding the threshold set the user
(see
XCV Threshold
on page 3-12).
In Test The STS-1 is going in test (applies to the Active
controller card only).
JTRACE (STS receive path trace)
The controller card has detected a change in the
receive path trace message. The message is
received in the J1 path overhead byte. This byte
is used to repetitively transmit a 64 byte (last two
bytes are a fixed CR/LF) string so the receiving
terminal in a path can verify its continued
connection to the intended transmitter.
Trap If enabled, the unit issues a trap when...