Filter
Top Products
Chapter 3. Configuration
61200659L1-1 MX2800 STS-1 User Manual 3-29
RFI-L (Line Remote Failure Indication)
The controller card is receiving a line remote
failure indication. RFI-L is declared when the
incoming line remote defect indication (RDI-L,
"110" pattern in bits 6,7, and 8 of the K2 line
overhead byte) last for 2.5 +/- 0.5 seconds.
RFI-P (Path Remote Failure Indication)
The controller card is receiving a path remote
failure indication. RFI-P is declared when the
incoming path remote defect indication (RDI-P,
"1" in bit 5 of the G1 path overhead byte for 5
contiguous frames) last for 2.5 +/- 0.5 seconds.
UEQ-P (Path Unequipped)
The controller card detects that the path is
unequipped. The path is unequipped if it is not
provisioned. Byte C2 of the STS path overhead
is set to zero.
SLM-P (Path Signal Label Mismatch)
The controller card is detecting a signal label
mismatch. A received signal label is
mismatched if it does not equal the locally
provisioned value or the value "equipped non-
specific".
TX LOS (Transmit Loss of Signal)
The controller card's transmitter has failed.
XCV (Excessive Code Violations)
The controller is receiving excessive code
violations exceeding the threshold set the user
(see
XCV Threshold
on page 3-12).
Trap If enabled, the unit issues a trap when...