Filter
Top Products
61200214L1-1 IQ Probe User Manual 9
Chapter 2. Installation
REAR PANEL
Connectors for the IQ Probe are located on the rear panel. The
DTE and DCE connectors provide DTE DB-25 interfaces. These
connectors can be cabled to V.35 or X.21 interfaces (using op-
tional ADTRAN adapter cables) or to an EIA-232 or EIA-530
interface (using a standard DB-25 cable). Part numbers for the
optional cables follow:
DB-25 to V.35 male adapter cable: 1200281L1
DB-25 to V.35 female adapter cable: 1200285L1
DB-25 to female DB-15 (X.21) adapter cable: 1200282L1
The DBU option card slot, control port, 10baseT LAN port, IEC
power receptacle, and power switch are also found on the rear
panel. Connector pin assignments are listed in the appendix
Pinouts. The IQ Probe rear panel is shown in Figure 2-1 with an
optional ESP DBU card installed. The connectors are described
in the sections following the figure.