Filter
Top Products
Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 41
© 2002, ADTRAN, Inc. Total Access 600 Series User Manual
TX Username
This is the username that is used when being authenticated by the PPP peer.
TX Password
This is the password or secret that is used when being authenticated by the PPP peer.
RX Username
This is the username used to authenticate the PPP peer.
RX Password
This is the password or secret that is used to authenticate the PPP peer.
IP
The IP menu contains the parameters for exchanging IP data with the PPP peer.
Mode
Setting to
ON
(def) will permit this connection profile to negotiate PPP IPCP with the PPP peer for
exchanging of IP packets.
Local IP
This is the IP address that is assigned to the PPP link when using numbered links. Leaving this as
0.0.0.0 means the Total Access 600 will determine its IP address using PPP IPCP. If the far end router
does not assign an IP address, the PPP link is left unnumbered.
Netmask
This network mask is applied to the IP/Local IP address for determining the PPP peer's network. If left
as 0.0.0.0, a standard network mask is used.
Remote IP
The PPP peer's IP address or network can be set here, if known. Leaving this at 0.0.0.0 means that the
Total Access 600 will determine the PPP peer's IP and network using the PPP IPCP.
NAT
The Total Access 600 can perform Network Address Translation. This feature is most widely used when
connecting to the Internet. The Ethernet network can consist of private network numbers. When this
profile is connected, all IP addresses on the Ethernet side are translated into the one real IP address
negotiated with the PPP peer (ISP). Multiple stations on the Ethernet side can access the Internet simul-
taneously. Setting this option to
O
N
will cause the Total Access 600 to perform NAT. In the
O
FF
(def)
position, the unit will route across the connection normally.
Route
The IP parameters are configured in this menu. Usually the Total Access 600 will automatically dis-
cover the PPP peer's networks using PPP IPCP and/or RIP.
• Route/Static Route
Selecting yes will add a static route to the remote peer to the route table.
• Route/Private
Selecting yes will prevent this route from being advertised.
• Route/Hops (1-16)
This value is the metric or number of hops that RIP will use in advertising the static route. The range is
1 to 16, where 1 is the default. The value 16 is considered an infinite distance (poisoned route).